HMS ST02 Bedienungsanleitung Seite 45

Product instructions (console function instructions, platform instructions)
Problem/code
The system is not working
Stop abruptly in normal condition
The key failure
The console shows incomplete or
missing lines
Display no heart rate
•
No power or no power on
•
Safety key are not in
place
•
Circuit breakage
•
•
E02 he IGBT is damaged or the
electromagnet is not plugged in
E-03 No resistance signal
Downtime during operation
E-04
(people coming down halfway)
E-05 Overcurrent protection
Infrared radiation sensor
E-06
malfunction
Magnetoresistor self-locking
E-07
mechanical switch open circuit
• The induction wire is not
inserted in place or the
E-08
wire is not good
•
Electrical system line fault
•
System failure
• Display plate screw loose
---- Safety key error
•
The induction wire is not
inserted in place or the
wire is not good
•
Electrical system line
fault
Probably reason
Safety key dropped
System faul
Invalid key
Replace the controller or
magnetoresistor.
The resistance sensor or controller
is abnormal.
Replace the motor or Controller
Defective infrared radiation sensor
or foreign object occlusion (the
radiation sensor is triggered
normally, and the fault is
automatically eliminated after 5
seconds)
Defective magnetoresistive device
or poor
wiring
Safety key falls off or console error
solution
• Connect the power
supply or turn the power
switch on to the "NO"
position
•
Put the safety key in the
right place
•
Check the input and
output of the system and
the communication line
•
. Relay the safety key
•
Ask the repairman to deal
with it.
•
Replacement of keyboard
and keyboard wiring
• Replacement of
motherboard
•
Replacement of console
No load detection
•
Check and connect or
replace the handle pulse
wire
•
Replace console
•
Replace console
• Tighten the screws
•
Check and connect or
replace the handle pulse
wire
•
.Replace console
EN
45