Atlantis T16 Benutzerhandbuch Seite 12

TROUBLE SHOOTING
VGA connection
Monitor: Check the Volume via OSD (AUDIO ADJUST-> VOLUME) and check that MUTE mode is not selected. In AUDIO
ADJUST->AUDIO INPUT select the correct source (LINE IN).
PC:Checkthat the AUDIO output is correct, check the connection between LINEOUT (of the PC)and LINEIN (on the
monitor).
The power LED light is too bright and creates noise (22")
Access Via OSD->SETUP
IMPORTANT PRECAUTIONS
Before using this device, please read all the instructions in this manual carefully.
2. Please keep the manual carefully for future reference.
Unplug this device from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners.
3.
Use a damp or wet cloth to clean. Please use LCDscreen detergent for cleaning if it is still dirty.
DO not use the parts not recommended by the manufacturer, otherwise it may cause a hazard.
4.
When unplugging the power cord of the monitor or adapter, please hold the plug with your hand,
5.
do not pull the cord directly.
6. DO not place any Object on the power cord. DOnot trample it either.
Do not use the device near water sources, e.g. bathtub, basin, kitchen sink, or washing machine. Do not
7.
place the device on a wet floor, or near a swimming pool etc. Do not touch the screen with your fingers
or other hard objects.
Slots and openings on the housing and its back or bottom are provided for ventilation.
8.
Toensure reliable operation of the components and to protect them from overheating, these openings
must not be blocked or covered placing the device on a bed, sofa, rug, or other similar surface.
The device should never be placed near or over a radiator or heater and should not be placed in a
built-in installation unless proper ventilation is provided.
9. Make sure that the device is at least 8 cm distance from the wall or other objects around when it is in use.
The power supply must respond to that stated on the rating plate. If you have any query about the
10.
power supply, please refer to the dealer or local power supply provider.
Ensure that the power socket and cord in use are able to take the sum Of the rated currency Ofall the
11.
products.
12. Observe all the warnings and instructions described in the manual.
DO not overload the power outlet or use any extension cord, otherwise it may cause fire or electric shock.
13.
Do not attempt to repair this device yourself since opening or removing covers may expose you to
14.
dangerous voltage or other hazards. Refer servicing to qualified service personnel.
Unplug this monitor or AC adaptor from the wall outlet and refer servicing to qualified service personnel
15.
under the following conditions:
When the power cord or plug is damaged or worn.
If the device has been dropped or its housing has been damaged.
b.
When the performance of the device deteriorates distinctly.
16. The power cord is the main facility to turn on/off the device; unplug it if the device is not used for a long
period of time.
Store the device at a place of good ventilation; avoid strong sunlight, high temperature or humidity.
17.
18. Store the device at a place at -200C550Croom temperature. Otherwise, it may cause permanent damage.
DO not install near heat sources (radiators, Stoves, radiators), in dusty environments, in a place
19.
subject to direct sunlight or in places subject to vibration.
The monitor must be placed on a flat and stable surface or, where appropriate, supported by a stand
20.
adequate vesa capable Of holding at least 8 kg. Never place the monitor on a bed, sofa, carpet.
MENU and deselect the POWER INDICATOR item.
EN