Eachine EX 2 Mini Bedienungsanleitung Seite 9

Status indicator
Front light
Sound of the drone
The aircraft sends out 'beep..
beep... beep... beep" continuously.
Flight
Before you take off, check and make sure that
1.The aircraft and the remote controller are full charged.
2.The propellers are installed correctly.
3. The motors work normally after unlocking.
Basic flight
Basic flight operations
I .Connect the remote
2.Unlock the aircraft after the detection of gyro of the aircraft is completed.
3.PuII up the throttle stick then the aircraft takes off, and control the aircraft flight by left/right stick.
4.Push the throttle stick to the bottom, lock the aircraft by press the lock button for long time,
5.Take out the battery from the aircraft.
Status lights of the drone
The front lights flash rapidly.
The front lights flash twice and stop
The front lights flash slowly or the
front/rear lights flash at the same time.
The front lights keep solid on and the
The front and rear lights keep solid on.
operations
step
controller with the aircraft.
for 2 seconds.
rear lights are Off.
Rear light
Description
The gyro is under calibration status.
The aircraft is not linked to remote
or the signal of the remote controller is lost.
The aircraft is underpowered and the remote
controller or the aircraft sends out "beep
The aircraft is under
The aircraft is under unlocking or flying status,
controller
lock status.