VEVOR IOG-1 Bedienungsanleitung Seite 8

● If the appliance needs to be repaired,please contact the technical service
center authorized by the manufacturer,adhere to the use of the original
vulnerable parts,repair by unauthorized individuals are dangerous,and the
warranty is invalid.
● The electrical appliance must be installed with grounding,and the internal
circuit must be tested by the technical personnel with electrical qualification.
● Do not use the electrical appliance outdoors.
● Do not plug the air outlet and air inlet.
● No epitaxial cable lines shall be used.
● Pull out the power plug before cleaning or maintaining the appliance.Do
not pull the cable to move the appliance.
● Please do not install the electrical appliance in a room with natural
gas,gasoline and sulfur,and it can not be installed close to the heat source.
● Do not use the electrical appliance on the slope ground.
● Be sure to maintain a distance of at least 45cm from flammable
materials(such as alcohol)or durable containers(e.g.aerosol tanks).
● Do not place heavy objects or hot objects on the top of the machine.●
Clean the filter screen regularly.
● In the process of transporting the electrical appliance,please keep it
vertical and place it on one side.When moving the electrical
appliance,please empty the water in the water tank first.After the
transportation,if you need to start it,please wait for half an hour.
● R290 It is a refrigerant that complies with the relevant environmental
standards.The cycle of the refrigerant in the electrical appliances is
closed.After the end of the service life,please submit the electrical
appliances to a special recycling center.
● Packages are recyclable,so it is recommended to place them in the
corresponding waste sorting recycling bins.
● The installation of the electrical appliance must be consistent with the
relevant national laws and regulations.
POWER
If you move the appliance,please restart it after half an hour.Before
inserting the wire plug into the power outlet,check:
● The main power supply system meets the power supply requirements
marked on the nameplate of the electrical appliance.
● Power sockets and circuits are suitable for this appliance.
● To match the power socket and the plug,please replace a matching
power plug with a qualified electrician.
● Power socket must have a grounding setting.
● Electrical cables must be replaced by the approved service
personnel.The manufacturer is not liable for not to with the safety rule.