MTB Montage- und Betriebsanleitung
Freitag
22.08.08
8:30
OK
Anpassung Datum+Uhrzeit
Durch Drehen des Bedienknopfs ist der Wochentag,
das Datum sowie die Uhrzeit anzuwählen. Änderungen
werden durch Drücken und anschließendes Drehen des
Bedienknopfs vorgenommen. Durch erneutes Drücken
gelangen Sie wieder zur Auswahl. Mit „OK" bestätigen Sie
die Änderungen und mit „Abrechen" verlassen Sie das
Menü ohne die Änderungen zu speichern.
Achten Sie darauf, dass der Wochentag korrekt
eingestellt ist, da dies Auswirkungen auf den
automatischen Funktionstest hat
Funktionstest - Seite 73
4.9.4.5. Passwort ändern
Mit der Passwortabfrage können die Einstellungen vor
unbefugtem Zugriff geschützt werden. Werksseitig
ist „0000" als Passwort eingestellt. Dieses Passwort kann
individuell gewählt werden.
Hauptmenü
Programmierung
BNS SV
Passwort
frage
siehe 4.8.6.3. Prüfbuch BT - Seite 70
22.08.2008
FRE
Neues Passwort:
0 * * *
Passwort
Das neue Passwort ist durch eine wiederholte Eingabe
zu bestätigen.
22.08.2008
FRE
Neues Passwort:
* * * *
Wiederholung: 0 * * *
Passwort
4.9.4.6. Inbetriebnahme
Um das BNS-Meldetableau auf Werkseinstellungen
zurückzusetzen gehen Sie wie folgt vor:
Hauptmenü
Programmierung
BNS SV
Inbetriebnahme
Passwortabfrage
Abbruch
siehe 4.9.1.
Passwortab-
15:30
15:30
MTB Mounting and Operating Instructions
Friday
22.08.08
8:30
OK
Date+Time
Turn the control knob to select the day of the week,
date and time. Press and then turn the control knob to
save any changes. Press the control knob again to return
to the selection menu. Confirm the changes with "OK"
or select "Cancel" to exit the menu without saving the
changes.
Please ensure that the weekday is set correctly,
as this affects the automatic function test
see 4.9.1. Function test on page 73
4.9.4.5. Changing the password
The settings can be protected against unauthorised
access using a password prompt. The password is set
to „0000" by default. You can choose your own password.
Main menu
Programming
SV
Password
4.8.6.3. Logbook DT on page 70
22.08.2008
FRI
New password:
0 * * *
Password
If you change the password, you will be asked to enter
it a second time to confirm the change.
22.08.2008
FRI
New password:
* * * *
Repeat: 0 * * *
Password entry
4.9.4.6. Comissioning
Proceed as follows to return the CLS mimic panel to the
factory default settings:
Main menu
Programming
SV
Comissioning
Cancel
BNS
Password entry
see
15:30
15:30
BNS
Password entry
77