Special Wash Cycles And Options - Whirlpool ADG 402 Gebrauchsanleitung

Special wash cycles
and Options
Notes:
EN
Optimum performance levels when using the "1 Hour" and
"Rapid" cycles can be achieved by respecting the specified
number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
contact@whirlpool.com
Wash options
If an option is not compatible with the selected wash cycle
(see table of wash cycles), the corresponding LED flashes
rapidly 3 times and beeps will sound.
Start Delay option
The start of the wash cycle may be delayed for a period
of time between 1 and 12 hours.
1. Press the START DELAY button: the corresponding symbol
appears on the display; each time you press the button, the time
(1h, 2h, etc. up to max. 12h) from the start of the selected wash
cycle will be increased.
2. Select the cycle and close the door: the timer will begin
counting down;
3. Once this time has elapsed, the indicator light switches off
and the wash cycle begins.
To adjust the delay time and select a smaller period of time,
press the START DELAY button. To cancel it, press the button
repeatedly until the selected delayed start indicator light switches
off. The wash cycle will start automatically as soon as the door
is shut.
The Start Delay function cannot be set once a wash cycle
has started.
36
Tablet option (Tab)
This option optimises washing and drying results.
When using Tablet, press the TABLET button; the
corresponding symbol will light up. If the button is pressed again,
the option will be deselected.
The "Tablet" option results in a longer wash cycle.
Multizone Option
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity and
detergent. Select the wash cycle and then press the MULTIZONE
button: the indicator corresponding to the chosen rack lights up
and the wash cycle starts only in the upper or lower rack.
Remember to load the upper or lower rack only, and to
reduce the amount of detergent accordingly.
LIGHT POINT
Some dishwasher models are equipped with a green indicator
light in the gap between the door and kitchen top providing
information on the phase of the current wash cycle. One of the
following operating modes can be selected:
a) Disabled function
b) When the cycle starts the light goes on for few seconds, stays
off during the cycle and flashes at the end of the cycle (default
mode)
c) The light stays on during the cycle and flashes at the end of
the cycle. If the delayed start was set, the light goes on either
for the first few seconds or the entire duration of the countdown,
based on whether mode b) or c) was set.
The light goes off every time the door is opened.
To select the mode you prefer, switch on the machine, hold
down button P until one of the three letters appears on the dis-
play, press button P until you reach the desired letter (or mode),
hold down button P to confirm the selection.