INSTALLING OR REPLACING THE DOOR PANEL
DE
• Installing the door panel is preliminary before the refrigerator installation.
• The thickness of door panel must be less than 4 mm.
EN
• If the thickness of the door panel is less than 2 mm, the dimension of it is
W 393 mm x H 1426∼1427mm.
IT
• If the thickness of the door panel is 2 mm∼4 mm, the dimension of it is
W 393 mm x H 1425∼1426mm.
ES
WARNING!
• The door panel has sharp edges and corners. To prevent cuts or abrasions when working on
FR
the refrigerator, be careful and wear cut resistant gloves.
NL
04
FI
DK
SE
REVERSING THE DOOR
Reverse the door as the following steps when needed:
• Open the door to 90°or more, see FIG.05.
• Remove the handle components(see FIG.06) with a cross screwdriver and handle cap (see FIG.07)
from the opposite side of the door, then exchange them and install each of them on the opposite side.
• Remove the locking catch with a cross screwdriver (see FIG.08) , pull out the locking catch adjuster
and rotate it 180°, push it into the locking catch base again, see FIG.09.
• Press down 1 with a flat screwdriver(see FIG.10), and pull out the upper hinge pin(note there is a
spring below).
• Remove the pin hole cap with a flat screwdriver, then install it on the opposite side, see FIG.11.
• Remove the refrigerator door by lifting it up until it clears the lower hinge pin, see FIG.12.
• Remove the lower hinge pin 2 with a flat screwdriver and the screw 3 (see FIG.13), then
exchange them and install each of them on the opposite side, see FIG.14.
• Remove the two screw caps with a flat screwdriver, then install them on the opposite side, see FIG.15.
• Position the refrigerator door on the lower hinge pin, press the upper hinge pin and spring into the
door, and push them into the upper hinge. see FIG.16.
• Finally install the locking catch assembly on the opposite side, the door is fixed now, see FIG.17.
• Check whether there are gaps between the door and body, if so, heat gasket with a dryer until the
gaps disappear.
CARBEST | Compressor Fridge CV140L | 713504
30