Care And Maintenance - Gm-Racing Graupneri/Sj Wp Parasit Micro Rennboot Rtr 92302 Bedienungsanleitung

Notice!
Protectthernodelandtransmitter a gainstdamageor slWping whiletheyarebeingtransported.
Notice!
Pay particular attention to the moders water-tightness. A model boat will sink if it takes on too much water.
Priorto everyuse,checkthe model f or anydamageandalso ensure the hullis watertight w heredriveshafts
and rudder shafts netrate the hull.
Notice!
Allow the model dry out good after it is used.
4.
Notice!
Be sure to check the water-tightness of shaft penetrations through the hull several times during the model's
maidenvoyage.If wateris intruding, r emovetheshaftsandlubricatethesterntubeWithsufficient g rease
order no. 570
Notice!
The electric rmtors built into tie model may not be throw•naway along with household waste. They must be
removed and tumed in at an appropnate disposal facility.
Notice!
Ifbatteries are connected inparÆel they m ay o nly beso connected
reciprocal effects could take place between the batteries and cause them darnage_Therefore. connect batte-
rics only lust before running the model and disconnect them again afterward, Batteries must never be stored
with connected Ilel wiri
Care!
Cleanthemodelaftereveryuse.Removeanywaterwhichmayhavehtruded_Ifwaterhas gotteninto RC
components, lay them out to dry en send thern to the responsible GRAUPNER service center for inspection.
Care!
Clean the model and transmitter only with suitable cleaning materials. A lint-free doth is suitable. Never use
p
chemical cleaning agents. solvents. gasoline, spirits or similar.
Care!
Afteroperating the lubricatedriveshaftswitha smalldropof oil on thebearings.Theoutershaftbear.
p
ingsfor thepropellersmustalso belubricated.Tolubricatethe drives.useonlyoil whichdoesnotcontaminate
or pollute water (e. order no. 206). At the end of the operating season. the shafts should be removed and
lubricated anew with a water-neutral rease e. . order no. 570 .
Environmental protection notices
The symbolon thisproduct.its operatinginstructions or packaging givesnoticethatthis groductmaynotbe discarded as
common household waste at the end of its service life. It must be turned over to a recycling collection point for electric and
electronic apparatus.
Tho materials can be recycledaccording to theirmarkings.Youmakean irnportant c ontribution to protectionof the
byutiäzing facilitiesfor reuse,material r ecydingorothermeansof exploitingobsoleteequipment.
Batteries mustbe removedfromtheunit anddisposedof separately at an appropriate collection point.Pleaseinquwe withlocalauthori-
ties about the responsible waste collection locations.
16 GM-Racing WP PARASIT micro Rennboot RTR
Important safety and operating
With the transmitter switched on, briefly press the Bind button on the receiver unit to bind the transmitter
and receiver. The LED that was blinking red will turn green after a successful binding process.
Protect all units from dust, dirt, moisture, vibrations and other foreign parts. Also, never expose these
units to excessively hot or cold temperatures.
Avoid mechanical jarring and pressure stresses. Always check units for damage to housings and cables.
•
Never pull on cables to disconnect cable connectors.
•
Avoid reversed polarity and short-circuit conditions oi any kind as well as excessive power supply vol-
tage. The devices are not protected against these conditions,
Use only components which have been specified and released by GRAIJPNER.
GRAUPNER recommends that only dry-cell (i.e. primary cell) batteries be used as the transmitter's pow-
er supply. The use of rechargeable
Never attempt to recharge the power supply's dry-cell (i.e. primary cell) battery. Only rechargeable (i.e.
secondary cell) batteries may be charged.
The battery must have an adequate charge and the remote control unit's range must be tested. If in
doubt, the transmitter's battery should be replaced when its charge state is unknown.
when t he model isoperated as otherwise
If water has intruded into RC components, dry them out then send them to the responsible
service center for inspection (see listing of responsible service centers at the end of these instructions).

Care and maintenance

Clean the model after every use. Immediately remove any water which has intruded by appropriate
means, e.g. with a kitchen towel or similar. Always leave covers open/off for an extended period so resi-
dual moisture can dry out.
Clean the model and RC components only with suitable cleaning materials. Please contact your dealer
for information
Lubricate shafts at regular intervals. Please contact your dealer for information about suitable, water-
neutral lubricants.
If the model is not to be operated for a long time, all moving parts (shafts, etc.) should be taken out,
cleaned and re-lubricated.
separate storage.
notices for the RC system
(i.e. secondary cell) batteries for this purpose is at one's own risk.
about this.
All batteries must also be removed from the model and the transmitter
Silicone
Coupler
GM-Racing WP PARASIT micro Rennboot RTR
5 PORT
GRAUPNER
for
17