Safety Instructions; Safety Symbols - Ecoflow Smart Meter Benutzerhandbuch

Disclaimer
Please read the product documentation thoroughly and ensure you understand it before using the
product. Improper use may cause serious injury, product damage, or property loss. Always refer to
the most up-to-date documentation available at https://www.ecoflow.com/support/download/. This
documentation takes precedence over all other versions. By using this product, you acknowledge and
agree to all terms and conditions stated in the documentation. EcoFlow is not liable for losses caused
by improper use or failure to adhere to the provided instructions. Subject to applicable laws and
regulations, EcoFlow reserves the right to the final interpretation of this document and all documents
related to the product.

Safety Instructions

CAUTION!
• Danger of electrocution. Mounting/installation of the device to the power grid has to be
performed with caution by a qualified electrician.
• Danger of electrocution. Every change in the connections has to be done after ensuring there is
no voltage present at device terminals.
• Use the device only with a power grid and appliances which comply with all applicable
regulations. A short circuit in the power grid or any appliance connected to the device may
damage it.
• Do not connect the device to appliances exceeding the given max load!
• Connect the device only in the way shown in these instructions. Any other method could cause
damage and/or injury.
• Do not install the device where it can get wet.
• Plug in or unplug the LAN cable only when the device is powered off! The LAN cable must not be
metallic in the parts touched by the user to plug it in or unplug it.
• Do not allow children to play with the buttons/switch connected to the device. Keep the devices
for remote control of EcoFlow products away from children.
• Only current transformers (CTs) compliant with local regulations and standards should be used
with this device.
• Before operating the current transformer (CT), ensure that the power supply is completely
disconnected and the circuit is de-energized.
• RECOMMENDATION: Connect the device using solid single-core cables with increased insulation
heat resistance not less than PVCT105°C (221°F).
• The protection provided by the device may be impaired when the device is not used in accordance
with the manufacturer's instructions.
• Indoor Use Only

Safety Symbols

CAUTION
Disconnect the device from all voltage sources before servicing.
CAUTION! RISK OF ELECTRIC SHOCK
Do not remove the cover (or back). No user serviceable parts inside. Refer servicing to
qualified service personnel.
READING MANUAL
Read the user manual and all safety instructions carefully before installation, operation,
and maintenance.
DOUBLE INSULATION
Equipment protected throughout by double insulation or reinforced insulation
ENGLISH
01