Closing The Door - Progress PG1803 Benutzerinformation

24 Progress
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the FastFreeze, or
after changing the tempera‐
ture.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.

Closing the door

1. Clean the door gaskets.
Possible cause
The FastFreeze is switch‐
ed on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
This is normal, no error
has occurred.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The FastFreeze or Shop‐
ping function is switched
on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The food products' tem‐
perature is too high.
The door has been
opened often.
There is no cold air circu‐
lation in the appliance.
2. If necessary, adjust the door. Refer to
assembly instructions.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
Refer to "FastFreeze function".
Refer to "Closing the door".
The compressor starts after a
period of time.
Attach the melting water outlet
to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "FastFreeze or
Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Open the door only if necessa‐
ry.
Make sure that there is cold
air circulation in the appliance.