Working Steps; Pre-Test; Start Tester - Autool Bt760 Bedienungsanleitung

WORKING STEPS

Pre-test

Start tester

It is applicable for automotive manufacturers, automotive mainte-
nance and repair workshops, automotive battery factories, automo-
tive battery distributors, and educational organizations, etc.
Connect tester
Shake the clamps back and forth to make sure they are well
●
connected.
Tester requires the two clamps well connected with the battery
●
poles, otherwise, the test can not go on.
The red to the positive and the black to the negative, then the
●
tester display will show the starting interface.
When the measured battery voltage is lower than 6.0V, the
normal test cannot be performed. Press OK to continue.
● According to the tester's prompt, press the [
select in sequence: Battery Test; Cranking Test; Charging
Test; Load Test; Language; Help
Battery Test Cranking Test
Charging Test Load Test
Languages Help
11
] keys to