Stanley FATMAX SFMCS600 Bersetzt Von Den Originalanweisungen Seite 7

Important Safety Instructions for All Battery Chargers
SAVE THESE INSTRUCTIONS: This manual contains
important safety and operating instructions for compatible
battery chargers (refer to Technical Data). Before using
charger, read all instructions and cautionary markings on
!
charger, battery pack, and product using battery pack.
Warning! Shock hazard. Do not allow any liquid to
@
get inside charger. Electric shock may result.
Warning! We recommend the use of a residual
current device with a residual current rating of 30 mA
&
or less.
Caution! Burn hazard. To reduce the risk of injury,
charge only STANLEY FATMAX rechargeable
batteries. Other types of batteries may burst, causing
@
personal injury and damage.
Caution! Children should be supervised to ensure
that they do not play with the appliance.
NOTICE: Under certain conditions, with the charger
plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign
material. Foreign materials of a conductive nature such
as, but not limited to, steel wool, aluminum foil or any
buildup of metallic particles should be kept away from
charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug charger before attempting to clean.
DO NOT attempt to charge the battery pack with
u
any chargers other than the ones in this manual. The
charger and battery pack are specifically designed to
work together.
These chargers are not intended for any uses other
u
than charging STANLEY FATMAX rechargeable
batteries. Any other uses may result in risk of fire,
electric shock or electrocution.
Do not expose charger to rain or snow.
u
Pull by plug rather than cord when disconnecting
u
charger. This will reduce risk of damage to electric
plug and cord.
Make sure that cord is located so that it will not be
u
stepped on, tripped over, or otherwise subjected to
damage or stress.
Do not use an extension cord unless it is absolutely
u
necessary. Use of improper extension cord could
result in risk of fire, electric shock, or electrocution.
Do not place any object on top of charger or place the
u
charger on a soft surface that might block the
ventilation slots and result in excessive internal heat.
Place the charger in a position away from any heat
(Original instructions)
source. The charger is ventilated through slots in the
top and the bottom of the housing.
Do not operate charger with damaged cord or
u
plug—have them replaced immediately.
Do not operate charger if it has received a sharp blow,
u
been dropped, or otherwise damaged in any way. Take
it to an authorised service centre.
Do not disassemble charger; take it to an authorised
u
service centre when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock, electrocution or fire.
In case of damaged power supply cord, the supply cord
u
must be replaced immediately by the manufacturer,
its service agent or similar qualified person to prevent
any hazard.
Disconnect the charger from the outlet before attempting
u
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
NEVER attempt to connect two chargers together.
u
The charger is designed to operate on standard 230V
household electrical power. Do not attempt to use it
on any other voltage. This does not apply to the
vehicular charger.
@
Charging a Battery (Fig. A1)
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature: approx. 24 °C.
The battery needs to be charged before first use and whenever
it fails to produce sufficient power on jobs that were easily done
before. The battery may become warm while charging; this is
normal and does not indicate a problem.
Note: The charger will not charge a battery if the cell temperature
is below approximately 10 °C or above 40 °C.
The battery should be left in the charger and the charger
will begin to charge automatically when the cell
temperature warms up or cools down.
Note: To ensure maximum performance and life of lithium-ion
battery packs, charge the battery pack fully before first use.
1. Plug the charger (8) into an appropriate outlet before
inserting battery pack (7).
2. The green charging light (8a) will blink continuously
indicating that the charging process has started.
3. The completion of charge will be indicated by the green
charging light (8a) remaining ON continuously. The battery
pack (7) is fully charged and may be removed and used at
this time or left in the charger (8).
4. Charge discharged batteries within 1 week. Battery life will
be greatly diminished if stored in a discharged state.
ENGLISH
5