Electrolux CONTROLBOX 24/7 Benutzerhandbuch Seite 5

1
IR transmitter
2
IR transmitter
Sends IR signals to your heat pump, and has a range of up to
10 metres.
3
Current indicator (green)
ON: External power supply connected.
OFF: External power supply disconnected.
4
Battery indicator (green)
ON: Normal battery status.
OFF: Battery disconnected or battery on/off switch is
switched off.
Flashing: Low battery level.
5
GSM indicator (red)
ON: No GSM signal. Seeking GSM signal.
OFF: GSM module has signal and working normally.
Flashing: Error on GSM module, no SIM card.
6
IR indicator (orange)
OFF: Normal setting
Rapid flashing: Sends IR signal via IR transmitter.
Slow flashing: Awaiting incoming IR programming signal
to IR receiver.
Lit for 3 seconds: IR signal programming successful.
7
IR receiver
Discreetly placed IR receiver. Reads IR signals through unit
housing, and does NOT need to be exposed by making a hole.
8
Temperature sensor
Reads current room temperature. Do not block this hole.
9
GSM test button
Press the button to read current GSM signal strength. The GSM
indicator will flash from 1 to 10 times, depending on strength
(1 = low signal strength, 10 = high signal strength)
10
IR test button
Sends a test signal to your heat pump.
- HL mode: Sends the following setting: "Heat 16°C"
with automatic fan speed".
- HX mode: Sends the following setting: "Heat 18°C"
with automatic fan speed".
- PM mode: Sends the programmed signal in the first slot.
If nothing has been programmed, no signal will
be sent.
11
External power supply
Connection for 12V DC, 1A current adapter.
12
Battery on/off switch
ON: The integrated battery will power the unit in the event
of power loss from the external power connection.
OFF: The unit will not work without an external
power supply being connected
13
SIM card holder
Cover for the SIM card holder and battery switch.
NB! When installing the SIM card, the battery switch must be in the
off position, and the external power supply disconnected.
5
DESCRIPTION