Programmable Mode; Initiation Of Remote Control Ir Signal - Electrolux CONTROLBOX 24/7 Benutzerhandbuch

Programmable mode

If you have a non-Electrolux heat pump or other appliance with an IR receiver you want to control, you can use programmable
mode. Up to 10 different fixed IR signals can be programmed in using individual commands.
NB!
To program your own IR signals, the unit must be in programmable mode, see chapter " Programming - entering heat pump model "
for further instructions.
Follow the steps below to program new or replace old IR signals.

Initiation of remote control IR signal

1.
Start by switching off your heat pump, so that the remote control shows that the pump is
switched off.
2.
The ControlBox24/7 must first read what type of IR signals your unit uses. Send the
following text message to ControlBox24/7:
RS
3.
The unit will go into learning mode, as shown by the IR indicator light flashing slowly for
1 minute, during which you must perform the next step.
4.
Aim your remote control at the IR receiver on the right side of the ControlBox24/7 and press the ON/OFF button on your
remote control to start the heat pump.
5.
The IR indicator will now indicate that an IR signal is being received by remaining lit for 3 seconds, and will then begin to flash
slowly again. Aim your remote control at the IR receiver on the right side of the ControlBox24/7 again, and press the ON/OFF
button once more.
6.
Once the initiation process is completed and successful, the ControlBox24/7 will confirm by sending the following text:
"Learning - SUCCESSFUL". NB! The initiation process will not save any IR signal unless it has read which IR format is
to be used.
11
PROGRAMMING
NB! When the command RS
is sent to ControlBox24/7,
all previously programmed
signals will be deleted.