Other Settings; Temperature Compensation - Electrolux CONTROLBOX 24/7 Benutzerhandbuch

OTHER SETTINGS

Temperature compensation

If your ControlBox24/7 is located where the temperature is consistently a few degrees higher or lower than where you
want to measure it, you can adjust the temperature on the unit.
To compensate the monitored temperature, send the following text message to your ControlBox24/7:
TADJ <X><YY>
= 0 for positive value, 1 for negative value.
X
YY =
05
0.5°C 1.0°C
If you want your ControlBox24/7 to show 2.5 degrees higher than the actual temperature measured, send the
following text message to the unit.
TADJ 025 Where "0" stands for "+", i.e. the temperature reported will show 2.5°C above the
actual temperature where ControlBox24/7 is located.
If you want to adjust the temperature shown downwards 1.5°, send
TADJ 125 Where "1" stands for "-", i.e. the temperature reported will show 1.5°C below the
actual temperature where ControlBox24/7 is located.
To deactivate temperature compensation, send:
TADJ 000
10 15 20 25
1.5°C 2.0°C 2.5°C
30 35
3.0°C 3.5°C
14