Installation - Electrolux CONTROLBOX 24/7 Benutzerhandbuch

INSTALLATION

Location
IR SIGNAL
ControlBox24/7 has two integrated IR diodes, which send signals via IR light. You must therefore locate the
unit with uninterrupted line of sight to the heat pump to be controlled. Test that the IR signal is received by
pressing the IR test button while holding the ControlBox24/7 where it is to be located, to ensure that the IR
signal is received.
GSM COVER
ControlBox24/7 has a built-in GSM module which makes it possible to communicate with the unit via text
messages. When deciding where to locate the unit, it is also important that there is sufficient GSM cover.
Hold the unit where you intend to place it and press the GSM test button. The GSM indicator light will flash
1 - 10 times. The higher the number of flashes, the better the GSM cover.
NB! GSM cover must be at least 4 flashes for ControlBox24/7 to work satisfactorily.
Installation
Once you have found the ideal location according to the IR signal's range and GSM signal strength, screw
the mounting plate supplied to the wall using the screws supplied (using plugs if necessary) and hook the
ControlBox24/7 into place. Test the IR and GSM strengths once more using the test buttons, to ensure that
everything is working as it should.
18