VEVOR M1B-LS-3301 Bedienungsanleitung Seite 6

equipment is provided. This should be connected and used correctly.
21. Check for damaged parts, lf a guard or some other part has been
damaged,check carefully before using the tool to ensure that it will operate
correctly and as intended. Make sure that moving parts are properly adjusted and
do not jam and that no parts are incorrectly fitted or damaged. Check for any other
factors that could influence functionality. Guards or other parts that are damaged
must be repaired or replaced by an authorised service centre. Unless otherwise
specified in these instructions. lf the power switch does not work, it must be
replaced by an authorised service centre. Do not use the tool if it cannot be
switched on and off using the power switch.
WARNING! The use of accessories or attachments other than those
recommended in these operating instructions can result in personal injury. Repairs
must only be carried out by qualified personnel. This power tool has been
manufactured in compliance with current safety standards and requirements.
Repair may only be carried out by qualified personnel using identical spare parts.
Failure to carry out repairs correctly can result in the risk of personal injury/death
or material damage
NOTE: A temporary voltage drop can occur when starting the machine, which
could affect other equipment. lf the main supply impedance Zmax is lower than
0.206ohms, this kind of interference is common. Contact your electricity supplier
for more information.
IMPORTANT SAFETY INSTRUCTIONS
1. Wear safety glasses, Don't send wood out feed side.
2. Before use, check that all screw connections are properly tightened.
3. Do not force the tool. Let the feed mechanism do the work. Never insert objects
or body parts in the outfeed.
4. Check regularly that the rubber roller and iron roller are clean. lf the rollers are
contaminated the workpiece will not be fed correctly- risk of personal injury.
5. Do not machine workpieces with many knots or sprigs.
6. The operating position is in front of the machine. Stand by the side of the in feed
table.
7. Remove any nails,screws and other metal objects from the workpiece before
- 4 -