VEVOR M1B-LS-3301 Bedienungsanleitung Seite 13

MAINTENANCE WARNING :
Turn off the machine and unplug the power cord before cleaning and maintenance,
Do not use water or other liquids to clean electrical parts.
CHECK AND REPLACING THE CARBON BRUSH
1. Turn off the machine, unplug the power cord and wait until all moving parts
have stopped completely.
2. Dismantle the carbon brush cover (W) as illustrated using a screwdriver.
3. Fit the new carbon brushes. Always replace both carbon brushes at the same
time.
4. Replace the carbon brush cover (W).
Overcurrent protective device correct use and replacement (I)
When the load power is too large, the current exceeds the load, so the overcurrent
protective device will jump!
1. When the overcurrent protective device jump,first disconnect the power supply
of the machine, then press the protective button to reset it
2. When pressing the protective button to reset it, don't reboot immediately. Need
to wait for the machine temperature to cool then start for use.
3. If overcurrent protective device jumps frequently. please replacement a new.
- 11 -