Exodraft RSV009-4-1 Bedienungsanleitung Seite 6

3000113-2011-06-22
Before fitting onto a steel chimney
Step Action
6
1 A flange (D) (supplied as extra) is used, fitted so that the
spigot end sits inside the chimney (E).
2 Place the mineral wool mat (B) on the flange (D) with
the aluminium foil facing upwards and cut a hole in the
mineral wool mat, the hole being the same diameter as
the flange hole.
3 Cut the corners of the mineral wool mat, so there is
room to fit the vibration dampers (C).
If a temperature sensor is to be installed with the chim-
ney fan, cut the aluminium foil on the mineral wool mat
to make room for the sensor; this also ensures that the
mat sits level on the chimney.
4 Fit the flange to the chimney fan, with the use of the
vibration dampers (C).
5 The fan can now be fitted onto the chimney.
A
B
C
D
E
GB