Installation Instructions - Exodraft Rsv009-4-1 Bedienungsanleitung

3000113-2011-06-22
Main components: The RSV has the following main components
4
a Top section
b Bottom section
c Motor
d1 Vane
d2 Centrifugal impeller
e1 Inlet for axial vane
e2 Inlet for centrifugal impeller
f Hinge

1.2 Installation instructions

Before fitting onto a chimney
the fan is to be mounted onto a brick chimney
the fan is to be mounted onto a steel chimney
the fan is a RSV 315, 400 or 450
RSV 009-012-014-016
The fan is designed to be fitted directly on top of brick or steel chimneys, as long as these are sta-
ble and level.
If....
RSV 160-200-250-315-400-450
m
g Safety mesh
h Handle
i Armoured cable and connecting cable
j Mineral wool mat
k Safety wire
l Location bracket, bolt and nuts
m
m Screws to fasten top and bottom section
(Alternatively use supplied wing screw, where
conditions allow)
the chimney must have location brackets - see below
a flange is required (supplied as an extra) - see below
the impeller is secured with a safety bracket for transporta-
tion.
Remove the transportation safety bracket located near the
impeller and check that the impeller can turn freely.
then..
GB
m