VEVOR SYC-5-X-V1 Bedienungsanleitung Seite 13

9.Always keep the product outside clean.
10. Please store the product in a dry and ventilated place.
11.If not used for a long time, please clean and empty the liquid in the
product.
12.Please replace the following consumable parts regularly:
Pipe,,Filling Nozzle
Problem
Not
absorbing
water
The pump
can't get the
liquid out
The control
panel light is
not on
TROUBLESHOOTING
Possible Cause
Machine first use or long time no
use, very few will not absorb
water, because the pump
internal dry result.
Weighing sensor failure
The power cord is not plugged in
The pipe inlet is blocked by the
bottom of the barrel
The power cord is not plugged in
This product is subject to the provision of European Directive
2012/19/EC. The symbol showing a wheelie bin crossed through
indicates that the product requires separate refuse collection in
the European Union. This applies to the product and all
accessories marked with this symbol. Products marked as such
may not be discarded with normal domestic waste, but must be
taken to a collection point for recycling electrical and electronic
devices.
Possible Solution
You need to add some water
from the intake pipe to the
pump and then start the
machine.
Replace weighing sensor
Reconnect the power cord
Change the pipe inlet position
Reconnect the power cord
- 11 -