Lutron Homeworks Interactive HWI-MI-230 Installationsanleitung

HOMEW
Installation Instructions
1. Mount HWl-Ml-230 in HWl.PNL-8-CE
CE. See Figure 2 for locations.
a. For Surface Mounted
and bolts with washers (provided).
b. For Recess Mounted
self-tapping screws (provided).
Danger - Locate and lock supply circuit breaker
(MCB) in the OFF position before connecting
power.
2. Connect Module Wire
tor wire harness that is shipped inside the Module Inter-
face assembly to the module harness connector on top
of the circuit board. Note:
has the longest length of cable between the end and the
second connector is the correct
Module Interface (this end will normally be indicated by
a serial number). Feed the end of the harness through
the module harness hole on the top end of the assembly
(see Figure I).
Figure 2 - Module Interface Location
HWl-PNL-5-CE
Preferred Power
Wiring Entry
o
Alternate Power o
Wiring Entry
LUTRON@
R KS
rnc6yc TM
or HWl.PNL-5-
Enclosures - Use No. 8 nuts
Enclosures - Use No. 12
Harness. Connect the 4 conduc-
The end of the harness that
end to attach to the
o
Module Location
(5 total)
HWl-Ml-230
Module Interface
Control Wiring
(PELV)
HWl-Ml-230
HomeWorksø InteractiveTM
Interface Assembly
Figure 1 - HWl-Ml-230
Power Input Plug
Manual Override
Rotary Address Switch
HWl-PNL-8-CE
Preferred Power
Wiring Entry
Alternate Power
Wiring Entry
This product may be covered under one or rnore of the following U.S. patents:
4,797.599; 5,170.068: 5.237207 and corresponding foreign patents. US.
and foreign patents pending. Lutron and HomeWorks are registered trademarks and
HomeWorks Interactive is a trademark
@ 2000 Lutron Eledronics Co.. Inc.
Module
Module Har-
ness Hole
0
Module Hamess
Connector (RPM Link)
Processor
Communication Link
Module Location
(8 total)
HWl-Ml-230
Module Interface
Control Wiring
(PELV)
Of Lutron Electronics CQ, Inc.