VEVOR TC-20B Bedienungsanleitung Seite 8

any remaining air. Air hose fittings and compressor body may get hot. Allow
fittings to cool before disconnecting, or wear gloves to prevent burns.
8.Perform maintenance on the compressor according to the instructions on
the following pages.
9.Clean the airbrush thoroughly IMMEDIATELY after EVERY use,
according to instructions on the following pages.
Note: Do not use the compressor continuously for longer than 20
minutes. Allow the compressor to cool down for 15 minutes after
every 20 minutes working cycle. The motor is equipped with a thermal
protector with automatic reset.
F. HOW TO MIX PANIT FOR AIRBRUSH
Warning: The airbrush shall be filled with special paint and diluted
accordingly. Do not use normal paint like lacquer and nail polish directly, or
the nozle will be blocked and cannot be used anymore. Most paints
designed for airbrushes do not need to be thinned. And other paint should
mixed with thinner/reducer. Each paint type requires a specific
thinner/reducer. We suggest to thin paint according to the manufacturer's
directions and mix thoroughly. Or refer to the following steps:
Step 1. Choose your paint. Different projects call for different paint, so
select the right paint for the job.
Step 2. Match the thinner/reducer to your paint.
You can use one or multiple of the
following when thinning
water-based airbrush paints:
You can use one of the following
when thinning solvent-based
airbrush paints:
• The Manufactured Reducer
(Water-Based)
• Distilled Water (But don't use a lot)
• Airbrush Acrylic Medium (Ether by itself,
or along side the others listed above)
•The Manufactured Reducer
(Solvent-Based)
• Mineral Spirits
• Lacquer Thinner
6