FLYLINKTECH BD10 Bedienungsanleitung Seite 13

The corresponding alarm situation is shown as below:
Error
A +Beepin g +"9"
+ Beeping+"8"
+ Beeping
+ Beeping+"6"
+ Beeping+"5"
+ Beeping+"4"
+ Beeping+"3"
Reason
Reverse Connection
Machine temperature is
too low or too high
Overcurrent Protection
Start the vehicle more
times without interruption
enter the safet
Short circuit protection alarm
The external voltage is higher
than the machine voltage
Low voltage protection alarm
connection between the clamps and the
ositive/ne
Restores the jump starter temperature
Stop starting the vehicle, the automatic
protection will disappear after 30s.
than 4
Stop starting the vehicle and the safety
and
mode will disappear after 10 minutes.
mode
Disconnect to cancell the protection.
Disconnect to cancell the protection.
Please charge the jump starter
as soon as possible to prevent damage
Solution
Please correct the
ative batter terminals.
value to -200C to 600C.
to the batte cell.
7