FLYLINKTECH BD10 Bedienungsanleitung Seite 12

I. Insert the plug of the smart clip completely into the jump start socket.
2. Connect the REDClamp to the vehicle's battery positive(+) terminal and connect the BLACK
clamp to the vehicle's battery negative(-)terminal.
3. Pressthe ON/OFFbutton and long press"BOOST "button until the LCDdisplays "BOOST"
4. Start the vehicle, and interval time between each starting must be OVER 30s; If after 3 times
failure, please stop trying again and check if there are problems of the vehicle engine or circuit.
5. When the vehicle is started, remove the smart clamp from the vehicle battery terminals within
30 seconds.
t t
Cli-10/o
START
ENGIN
o 0 o o