First Test - Insize 8701 Bedienungsanleitung

Menu
- Factory setting* - User setting
- STOP - CLOC (Time
- AUTO (Automatic weightless shutdown)
- ESC
- LOSE Weight-loss rate setting
Note: Those marked with are factory defaults

7. FIRST TEST

In the first measurement, the equipped sample (glass fiber filter paper with water) is used to measure the water
content. During the first measurement, the operation is according to factory settings.
» Connect the moisture analyzer to the power supply and wait until "0.000 g" displays.
» Press [Tare] button, open the heating chamber, place the sample, close the heating chamber, and press [Start]
button to do a drying test according to the default settings. You can monitor the process on the display
(temperature, drying time, weight).
» Display the current temperature of the heating unit, the past drying time, and the current mass or moisture
content after drying (press the unit conversion button [Unit] to freely switch between mass and % content).
» Press [Stop] button to end the test at any time. The final moisture content will be displayed.
» Press the [Tare] button to return to the normal weighing state and remove the sample.
! Burn hazard: Samples, sample trays, and brackets are now very hot! After the drying process is completed,
open the heating chamber and gently remove the sample tray using the sample tray bracket.
8. TESTING PROCESS
» Set heating method, time, temperature, and shutdown mode.
» Prepare the sample:
1. Place the empty sample tray on the sample tray bracket
2. Press the [Tare] button to remove the weight of the sample tray
3. Take out the sample tray and place the sample, preferably greater than 0.5 g
4. Distribute the sample evenly on the sample tray
» Place the sample tray containing the sample back on the bracket, and the display screen displays the weight
of the sample. Close the heating chamber.
» Press the [Start] button to start the measurement.
» The display screen displays the current weight value, and press the [Unit] button to convert the current
measurement result.
» After the measurement is completed, the display screen displays the final sample moisture content, press the
[Tare] button to return to the normal weighing mode.
» Press the [Print] key to send the current measurement results to a printer or other peripheral device.
Note: You can press the [Stop] button at any time during the test to terminate this measurement.
www.insize.cz
shutdown)*
- A1
- A2*
- A3
- A4
- ESC
*
www.insize.sk www.insize.hu www.insize.at