Herunterladen Inhalt Inhalt Diese Seite drucken
Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
120cm Solar Blossom Tree
Item No:
P197 / 664490
Instructions for Use
Please read and retain these instructions for future reference
READ THE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND INSTALLATION
BEFORE FIRST USE
: Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1.
Set switch (located on the back of solar case) to
placing it under direct sunlight for at least 8 hours.
2.
The light will work automatically. It will automatically charge under direct sunlight during the daytime and illuminate
at night.
NOTE:
To verify that the switch is correctly in the
should turn on automatically.
IMPORTANT:
1. Install the solar product in an area where it can get direct sunlight.
2. Leave the switch to
"S" OR "F"
3. Select an outdoor location away from other light sources at night, such as streetlights. It may cause the product not to
turn on automatically at night.
4. Duration of light depends on solar product's level of sunlight exposure, geographical locations, weather conditions
and the hours of daylight.
MAINTENANCE AND TROUBLESHOOTING:
1.
Make sure the switch is set to
2.
Keep the solar panel clean.
If solar product does not light up after it has been used for around 8 – 12
3.
months, replace the rechargeable batteries as they may be weak or worn
out. (Battery 1 pc "AA" 1.2v 800Mah, Ni-MH, Rechargeable– Same
equivalent type as recommended must be used).
Battery replacement:
Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not
included).
Step2: Remove the exhausted battery and install 1 pc new AA rechargeable battery according
to the +/- polarity as beside image. Open the compartment carefully and ensure that welding
wires inside the battery terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is
properly sealed.
v001: 16/09/24
ENGLISH INSTRUCTIONS
"S (steady on)" OR "F (flash)"
"S" OR "F"
position, cover the solar panel with your hand and the light
position.
"S" OR "F"
position.
.
position. Charge the solar product by
Inhaltsverzeichnis
loading

Inhaltszusammenfassung für Gainsborough P197

  • Seite 3 GERMAN INSTRUCTIONS LESEN SIE DIE ANLEITUNG VOR DER MONTAGE UND INSTALLATION SORGFÄLTIG DURCH. VOR DEM ERSTEN GEBRAUCH: Entfernen Sie die Schutzfolie vom Solarmodul. AUFLADUNG UND BETRIEB: Stellen Sie den Schalter (auf der Rückseite des Solargehäuses) auf „S (Dauerlicht)“ODER „F (Blinken)“ stellen.
  • Seite 4: Pflege- Und Reinigungshinweise

    • DIE VERWENDUNG VON ZUBEHÖR ODER ANBAUGERÄTEN, DIE NICHT VON COOPERS OF STORTFORD EMPFOHLEN WERDEN, KANN ZU VERLETZUNGEN FÜHREN UND EINE EVENTUELLE GARANTIE UNGÜLTIG MACHEN. • TAUSCHEN SIE DIE BATTERIEN AUS, WENN SIE DAS GERÄT ÜBER EINEN LÄNGEREN ZEITRAUM STEHEN LASSEN ODER NICHT MEHR AUFLADEN.
  • Seite 11 Distributed by / Verteilt durch / Distribué par. The Enterprise Department Ltd. 11 Bridge Street, Bishops Stortford Herts, UK, CM23 2JU Tel: 0330 331 0300 NI/EU: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France Tel: (+44) 1279 701269 DE/FR/CZ/SK: hergestellt für 3Pagen Sankt-Joeris-Strasse 16-28 53477 Alsdorf...

Diese Anleitung auch für:

664490

Inhaltsverzeichnis