Gainsborough M181 Bedienungsanleitung

Set 12 Traditional Solar Path Lights
Item codes: M181 / 612710
Instructions for Use
Please read and retain these instructions for future reference
Power Details:
AAA battery (Rechargeable)
1.2v 100Mah, Ni-MH.
Please read this instruction manual thoroughly before starting and ensure you are familiar with the
operation of your new Set 12 Traditional solar path lights.
BEFORE FIRST USE:
Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. There is an "on/off" switch at the back of solar panel case, twist the plastic lamp shade anti-
clockwise direction and find the switch.
2. Push the switch to "ON" position.
3. Replace the cover and position the light in a sunny location.
4. Charge the solar product by placing it under direct sunlight for at least 8 hours.
5. The light will work automatically. It will charge under direct sunlight during the daytime and illuminate
at night.
NOTE: To test the lights simply cover the solar panel with your hand and the light should turn on
automatically.
WARNINGS AND SAFETY INSTRUCTIONS:
WHEN USING ANY APPLIANCE, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED:
•
READ ALL INSTRUCTIONS BEFORE USE.
•
FOR DOMESTIC OUTDOOR USE.
•
NOT FOR COMMERCIAL USE.
•
BEFORE USE, CHECK THOROUGHLY FOR ANY DEFECTS AND DO NOT USE IF DEFECTS ARE FOUND. TAKE
CARE NOT TO DROP THE APPLIANCE AS HEAVY IMPACTS MAY CAUSE INTERNAL DAMAGE.
v001: 06/11/23
ENGLISH INSTRUCTIONS
ALWAYS USE ALKALINE BATTERIES.
DO NOT USE LITHIUM BATTERIES.