EWT QUBE2MB Bedienungsanleitung Seite 11

OSCILLATION (QUBE2MWO ONLY)
OVERHEAT SAFETY
heater off automatically. To bring the heater back into operation, remove the cause of overheating, then turn off the electrical
supply to the heater for a few minutes.
If the cut-out operates repeatedly, contact your supplier.
CLEANING AND MAINTENANCE
Always unplug the appliance before cleaning it:
• Clean the surface of the appliance using a soft cloth, do not use any water.
• If the appliance is very dirty, clean the surface using a damp cloth (add a non-corrosive cleaning product if required.
• Do not use corrosive detergents, corrosive solvents or chemical products.
• Do not use an abrasive sponge, scouring pad or hard brush to clean the appliance.
• Do not immerse the main body of the appliance into water.
• Ensure that the motor and the other electrical components do not come into contact with water.
• If the appliance is not to be used for a long period, pack it away carefully. Store it in a dry and ventilated area where it will
not be affected by dust.
GUARANTEE
This EWT ® appliance comes with a two- (2) year guarantee which begins on the date of purchase and only applies to use
under normal conditions. The guarantee does not apply to damage incurred as a direct or indirect result of inappropriate use,
negligence, improper use, accidents, improper repairs or lack of maintenance. Please keep your receipt/invoice as proof of
purchase.
EXCLUSIONS FROM GUARANTEE
• Normal wear and tear of parts,
• Deterioration following incorrect use,
• Failure to respect the instructions manual or the maintenance and safety instructions,
• Damage arising from faulty maintenance or lack of maintenance,
• Damage caused by exterior factors (lightning...),
• Abnormal use of the machine,
• Storage in poor/inappropriate conditions,
• Impacts,
• Immersion of the appliance
• Expiry of guarantee.
The heater can be switched into oscillation mode by pressing the switch on the rear of the oscillation
base, see 9. - Fig1.Position ' ' will turn oscillation on and position ' ' will turn oscillation off, see
Fig.4. The heater oscillates back and forth on its base through 90 degrees. Oscillation feature
provides Heating and Cooling effect across a wide area. This is particularly useful for providing
maximum coverage for Heating or Cooling effect quickly and efficiently.
FR EN DE NL PL SV
11