EDIFIER X3 Pro Kurzanleitung

True Wireless Earbuds with Active Noise Cancellation
EN 1. Power ON/OFF
Take out or place in both earbuds to power on/off.
2. First pairing
1. Once powered on, the earbuds will auto-enter Bluetooth pairing.
2. Select "EDIFIER X3 Pro" from your device list to connect.
3. Pairing for new device
1. Once powered on, the earbuds automatically reconnect to the
last device used.
2. If the connection fails, the earbuds enter Bluetooth pairing mode
in 10 seconds.
3. If manually disconnected, the earbuds enter pairing mode
immediately.
4. Select "EDIFIER X3 Pro" from new device's list to connect.
4. Multipoint connection
①
②
③
1. While the earbuds are paired, disconnecting them from deivce A
will auto-enter Bluetooth pairing mode.
2. Go to device B settings and select "EDIFIER X3 Pro" from the
product list to connect.
3. Select "EDIFIER X3 Pro" from the list on device A to reconnect.
Note: For subsequent use, the earbuds will automatically reconnect
to the two devices used last time.
5. Reset
1. Take the earbuds out of the case.
2. Quickly tap both touch areas 5 times to finish factory reset in 8
seconds.
6. Charging
Input: 5V 200mA(Earbuds)
Note: Make sure the USB-C port is completely dry before charging.
7. Controls
Note:
1. Default sound control: Noise cancellation on
2. "x2" double tap; "x3" triple tap
X3 Pro
Manual
1s
Bluetooth
EDIFIER X3 Pro
A
L
x2
x2
x2
x3
Bluetooth
EDIFIER X3 Pro
Bluetooth
EDIFIER X3 Pro
A
Bluetooth
EDIFIER X3 Pro
B
Bluetooth
EDIFIER X3 Pro
A
Bluetooth
EDIFIER X3 Pro
A
Bluetooth
EDIFIER X3 Pro
B
5V 1A(Charging Case)
R
x2
x2
x2
x3