Herunterladen Diese Seite drucken

JDbug Pro 1 Bedienungsanleitung Seite 4

Vorschau ausblenden Andere Handbücher für Pro 1:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

B. To release the folding mechanism, grasp the T-tube with one hand between
WARNING:
Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter. Make sure
others are standing clear.
C. The joint lever is spring-loaded and will automatically lock in the upright
D. To adjust the height of the handlebars, unlock the steering tube by pulling
WARNING:
Failure to properly engage the quick-release clamp may cause the T-tube to telescope up or down
while riding which may cause you to lose control and fall. With the quick-release
and engaged, the handlebars will not move up or down.
E. The tension of the quick-release
3. Check Before Riding
A. Collar Clamp.
the collar clamp and the quick-release clamp and, with the other hand, pull
up the joint lever up to release the steering column from the locked position
and allow you to pivot it to the upright position.
position when fully upright.
outward on the quick-release lever. Slider the T-tube to the desired position
and secure by pushing inward on the quick release clamp.
tightening or loosening the Allen bolt. Be careful not to over-tighten. You
should always be able to open and close the quick-release
and the t-tube should telescope freely with the quick-release open.
3
clamping
mechanism
Using the correct size Allen wrench, check that
the collar clamp bolt is tightened securely (30 to
60 inch-pounds torque). This item is tightened
and quality-inspected at the factory, but there is
a slight chance that the effects of shipping or
handling may have caused this bolt to loosen.
properly adjusted
can be adjusted
by
lever by hand

Werbung

loading