Cleaning The Device - Mptech Flexispace Bedienungsanleitung

EN © 2024
Make sure your device is turned off. Place the vacuum cleaner in
the wall holder and press the handle until you hear a
characteristic click. Connect the power supply plug to the mains
socket. The charging indicator diodes on the device control panel
will light up one by one to indicate charging. Once fully charged,
all indicator lights will glow continuously. After charging is
complete, disconnect the power supply plug from the charging
socket.
TURNING THE DEVICE ON AND OFF
After assembling the device and selecting the
appropriate brush, press the
device's control panel to turn on the vacuum
cleaner. After switching on, the device
operates at medium suction power. Pressing
the + and – buttons increases and decreases
the suction power by one level respectively.
After finishing work, turn off the device by pressing the
again.

5. Cleaning the device

WARNING! The vacuum cleaner base, battery, foldable tube,
electric brush and wall holder with power supply cannot be
immersed in water or washed under running water.
Cleaning can only be carried out when the vacuum cleaner
is turned off, cooled down and not connected to the power
supply in the wall mount.
Do not use any chemical, alkaline, abrasive or disinfectant
for cleaning as they may have a harmful effect on the
device's components.
The vacuum cleaner base and its components can only be cleaned
with a dry cloth or paper towel. In case of heavy dirt, you can use a
cloth slightly moistened with lukewarm water and wring out the
excess. Afterwards, immediately wipe the washed area with a dry
cloth or paper towel and leave the device to dry.
button on the
23
All rights reserved
button