mPTech Flexispace Bedienungsanleitung Seite 22

EN © 2024
assembly buttons to release the lock and pulling the components
to disconnect them. To disconnect the dust container from the
vacuum cleaner base, press the lock button on the left side of the
vacuum cleaner base and disconnect the elements.
CHARGING
The wall mount must be mounted on the wall. Before
installation, carefully measure the height at which it should
be attached.
appropriate for the given type of wall and ensure that the bracket
is mounted firmly and securely. Make sure there are no pipes
(gas, water, air) or electrical cables, wires or ducts directly behind
the mounting area. The wall mount must be installed in
accordance with regulations and applicable rules/standards
(national or local regulations may apply).
Only use the power supply supplied with the device. Using
other power supplies may damage the device.
Before using the product for the first time, the device's
battery should be fully charged. It may be necessary to
perform several charging and discharging cycles to obtain the
full capacity of the battery.
Avoid over-discharging the battery. This may damage or
shorten the life of the battery.
The device may become warm while charging. This is a
normal phenomenon and should not affect the durability or
performance of the device. Do not leave the charging device
unattended, as this may result in fire or damage to the device or
utility equipment in the charging area.
For installation, use mounting
22
All rights reserved
accessories