RUSTA 9000 BTU Gebrauchsanweisung Seite 22

The evaporator filter can take out like fig.
• To avoid possible cuts, avoid contacting the metal parts of the appliance when
removing or re-installing the filter. It can result in the risk of personal injury.
Use a vacuum cleaner to remove dust accumulations from the filter. If it is very dirty,
immerse in warm water and rinse a number of times. The water should never be hotter
than 40 °C (104 °F). After washing, leave the filter to dry then attach the intake grille
to the appliance.
START OF SEASON CHECKS
Make sure the power cable and plug are undamaged and the earth system is efficient.
Follow the installation instructions precisely.
STORAGE
When the device is not in use:
To empty the internal circuit completely of water, remove the cap (fig. below).
Run off all water left into a basin. When all the water has been drained, put the cap
back in place.
Clean the filter and dry thoroughly before putting back.
Drain outlet
Drain cap
Strictest operation environment:
Cooling mode: 18 °C–35 °C (64 °F–95 °F), 30 % RH~90 % RH
22