RUSTA 9000 BTU Gebrauchsanweisung Seite 13

WINDOW SLIDER KIT INSTALLATION
The window slider kit has been designed to fit most standard vertical and horizontal
window applications, however, it may be necessary for you to modify some aspects
of the installation procedures for certain types of windows. The window slider kit
can be fastened with screws.
NOTE: If the window opening is less than the minimum length of the window slider kit,
cut the end without the hold in it short enough to fit in the window opening. Never cut
out the hole in window slider kit.
Cut on opposite
side of hole.
PARTS
A. Panel
B. Panel with one hole
C. Screw/Pin
1. ASSEMBLY
Slide Panel B into Panel A and size to window
width. Windows sizes vary. When sizing the
window width, be sure that the window kit
assembly is free from gaps from gaps and
or air pockets when taking measurements.
2. LOCK THE SCREW/PIN
Lock the screw/pin into the holes that
correspond. With the width that your window
requires to ensure that there are no gaps or
air pockets in the window kit assembly
after installation.
LOCATION
• The unit should be placed on a firm foundation to minimize noise and vibration.
For safe and secure positioning place the unit on a smooth, level floor strong
enough to support the unit.
• The unit has casters to aid placement, but it should only be rolled on smooth, flat
surfaces. Use caution when rolling on carpeted surfaces. Use caution and protect
floors when rolling over wood floors. Do not attempt to roll the unit over objects.
• The unit must be placed within reach of a properly rated grounded socket.
13