Device Use; Cleaning And Maintenance - Expondo Rckt-1940 Betriebsanweisungen

3.4.

Device use

NOTE: a burning smell may be detected during first use. This is normal and should disappear after a
short time. Ensure that the room is well ventilated.
Operation indicator lamp (5) will go on when the desired mode is selected and toast grid (8) will start
automatically. Select the operation mode (4) and grid rotation rate (3) appropriately for the desired level
of baking. The lower the range of grid rotation rate the higher is the speed of the grid and the lighter the
toast will be. On the other hand, the higher the range of grid rotation rate is set, the lower the grid
rotation will be and the more the toast will be toasted. To make sure the resulting baking effect is
satisfactory, put two slices of bread into the toaster and check the final result. The device features two
options for inserting the bread:
using the bottom (2) or the rear (10) tray. For bread to appear on the bottom tray after baking (2) close
and lock the rear cover (11a). For bread to appear on the rear tray after baking (10) the cover must remain
open (11b). Allow 10 - 12 minutes for the device to heat up to its maximum temperature.
3.5.

Cleaning and maintenance

a) Shaking, crashing and turning upside down of the device should be prevented when transporting it.
Store it in a properly ventilated location with dry air and without any corrosive gas.
b) Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
c) Always unplug the device before cleaning or putting it away.
d) Use only non-corrosive cleaners to clean the surface.
e) Use only mild, food-safe detergents to wash the device.
f) After cleaning the device, all parts should be dried completely before using it again.
g) Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
h) Do not spray the device with a water jet or submerge it in water.
i) Do not allow water to get inside the device through vents in the housing of the device.
j) Clean the vents with a brush and compressed air.
k) The device must be regularly inspected to check its technical efficiency and spot any damage.
l) Use a soft, damp cloth for cleaning.
m) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN