Preparing For Use; Assembling The Device - Expondo Rckt-1940 Betriebsanweisungen

6. Crumbs drawer
7. Feeder
8. Grid for toasts
9. Power cord connection
10. Rear tray
11. a. view with closed cover (toast will appear on the bottom tray)
b. view with open cover (toast will appear on the rear tray)
3.2.

Preparing for use

APPLIANCE LOCATION
The temperature of the environment must not be higher than 45 °C and the relative humidity should be
less than 85%. Ensure good ventilation in the room in which the device is used. The distance between the
back of the chain toaster and the wall should be at least 20 cm, minimum distance between the sides of
the device and the walls should be at least 10 cm on each side and 35 cm between the top of the device
and the ceiling. Keep the device away from hot surfaces. Operate the device on flat, stable, clean,
refractory and dry surfaces out of the reach of children and people with mental disabilities. Install the
device making sure that constant access to the main plug is ensured. The power cord connected to the
appliance must be properly grounded and correspond to the technical details. Before first use, remove all
elements and clean them along with the entire device.
Disassemble the device and all its components and clean them before the first use.
3.3.

Assembling the device

EN
1. Assemble the device feet.
2. Attach the feeder.
3. Holes for feeder mounting.
4. Insert the bottom tray from underneath
and hang it on the protruding hinges.
5. Place for attaching the rear tray.
6. Location of hinges for bottom tray.
7. To attach the rear tray loosen both
screws, insert the tray and tighten the
screws.