Electrical Safety; Safety In The Workplace - Expondo Rckt-1940 Betriebsanweisungen

ATTENTION! Electric shock warning!
ATTENTION! Rotating parts, entanglement hazard!
Protection Class 1. Grounding required, basic insulation.
ATTENTION! Hot surface, risk of burns!
Only use indoors.
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in
some details may differ from the actual product.
2. Usage safety
ATTENTION! Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Chain toaster.
2.1.

Electrical safety

a) The plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching
sockets reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment. Water getting into the device increases the risk
of damage to the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cable only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e) Do not use the device if the power cord is damaged or shows obvious signs of wear. A damaged power
cord should be replaced by a qualified electrician or the manufacturer's service centre.
f) To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
g) ATTENTION! DANGER TO LIFE! While cleaning, never immerse the device in water or other liquids.
h) Do not use in very humid environments or in the direct vicinity of water tanks.
i) Prevent the device from getting wet. Risk of electric shock!
2.2.

Safety in the workplace

a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use common sense when working with the device.
b) Do not use the device in a potentially explosive environment, for example in the presence of
flammable liquids, gases or dust. The device generates sparks which may ignite dust or fumes.
c) If you discover damage or irregular operation, immediately switch the device off and report it to a
supervisor without delay.
EN