marposs Quick digit S12,5 BASIC Gebrauchsanweisung Seite 8

4. Favourite key
E
The «favourite» key gives direct access to a predefi ned function, and can be confi gured according to the needs of the
user. In order to assign a function to the «favourite» key, give a prolonged press on
function:
0 dAtA
Validation of selection: By a prolonged press on
Note: a function can also be assigned via RS232 using the command <FCT + Function No.>
5. Switching off
The dial gauge goes automatically into stand-by if not used for 20 minutes.
Stand-by mode can be forced by a prolonged press (> 2 sec) on
In stand-by mode, the value of the origin is retained by the sensor (SIS mode), and the instrument automatically restarts
with any movement of the measurement probe.
Data transmission
(default)
example: Hold display = <FCT1>
1 Hold
Hold display
or a short press on
SET
:
MODE
8
, and then select the required
2 SEt
Zero reset
or
MODE
123. 4 56
mm
SET
>2s