NTech RoofOn Multi Dig Betriebsanleitung Seite 22

ASSEMBLY INSTRUCTIONS
CONTOUR WELDING DEVICE (OPTION)
Contents: Art.-No. 5232550
2 pcs of contour rollers with holder and screws
1 pcs allen key SW6
1 pcs of assembly instructions
E
A
B
Assembly:
Loosen the two caps (A) with an Allen key
SW6 and pull off the rollers (B).
Slide the holders (C) of the two contour rollers
(D) onto the shaft so that they cannot twist,
and tighten the screws (E) hand-tight.
MECHANICAL OVERLOAD PROTECTION
To replace the overload protection, the screw (A) is loosened. The replacement pins (B) are between the two
washers (C1 / C2). Pull the pressure roller (D) off the shaft (F), remove the remains of the old pin (E) from the
shaft (F) and pressure roller (D) and insert one of the replacement pins (B) into the groove (G). Put the
pressure roller (D) carefully and without tilting back onto the shaft (F). Insert washer (C1), position the
remaining replacement pins (B) on the washer (C1) and screw in and tighten the screw (A) with washer (C2).
C
D
F E D
22 23
www.ntech-gmbh.de www.ntech-gmbh.de
Dismantling:
Loosen the two screws (E) and pull off the
contour rollers (D).
Push both rollers (B) back on and tighten
the caps (A) hand-tight with an Allen key
SW6.
G
C1 B C2
5232146.1
A