Safety Instructions; Occupational Safety - Ntech Roofon Multi Dig Betriebsanleitung

SAFETY INSTRUCTIONS

The following warning symbols are used to indicate the existing dangers:
Risk of crushing
The operator is responsible for compliance with the safety standards.
Before the machine is started up, the operator (s) must be instructed on these safety standards.

OCCUPATIONAL SAFETY

The automatic welding machine is manufactured according to recognized rules of technology.
The latest safety standards are taken into account so that work-related dangers to the life and health of the
operator are excluded if the device is used as intended.
DANGER AREA
The main danger area of the automatic welding machine is the swivel nozzle, which can be heated to
temperatures of up to 620° C. The use of thermal protection gloves is recommended.
When swiveling the welding nozzle, attention must be paid to the risk of pinching and crushing.
BASIC SETTINGS OVERLAP WELDING MACHINE
Basic setting:
Adjustment work should only be carried out when the nozzle is cold (risk of burns!).
Setting nozzle:
A
Loosen the screws (A) with an Allen
key SW4
!!! Risk of burns in the work area !!!
B
Adjust the nozzle distance to the
pressure roller
www.ntech-gmbh.de www.ntech-gmbh.de www.ntech-gmbh.de www.ntech-gmbh.de
Risk of burns
38-42mm
nozzle tip (C) touches the surface
16 23 23 23
D
2mm
Adjust the nozzle position
Loosen the screws (B) and turn
the nozzle slightly so that the
and the area (D) is approx. 1mm
away from the surface.
C