Ronix RP-U100C Bedienungsanleitung Seite 26

- Fuse has blown
- Incorrect mains voltage
- Thermal sensor activated
- Nozzle partially blocked
Fuse blows Fuse too small
- Air in inlet hose
Inadequate supply of mains
water
Machine pulsating
- Nozzle partially blocked
- Hose kinked
Machine often
Pump/spray gun is leaking
Centre
by itself
- Pump/hoses or accessory
frozen
but no water - No water supply
comes out
- Nozzle blocked
24
Compact Universal High Pressure Washer 100 bar
- Replace fuse
- Check that the main voltage
corresponds to specification on the
model tag
- Leave the washer for 5 minutes to cool
down
- Clean the nozzle
amp consumption of the machine
- You may try without the extension cord
Allow machine to run with open trigger
until regular working pressure resumes
- Check the water supply corresponds to
- Avoid using long, thin hoses (min. 1/2")
- Clean the nozzle
- Straighten out hose
- Wait for Pump/hoses or accessory to
thaw
- Connect inlet water
- Clean the nozzle