Ronix RP-U100C Bedienungsanleitung Seite 22

WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 0.7 MPa.
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
Check the electrical supply voltage and frequency (Volt/Hz) correspond to
those specified on the washer rating plate. If the power supply is correct,
you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds
to allow air to escape and discharge residual pressure in the hose.
- Keeping the trigger pressed push the switch to start the motor.
- When re-starting the motor, always keep the trigger pressed.
20
Compact Universal High Pressure Washer 100 bar