Villager Quix Originale Gebrauchsanweisung Seite 44

NOTE: Boundary wire front of the charging base should be straight for 1m without corners
or obstacles to ensure proper docking.
The charging station must be positioned on relatively level ground. it must not be
positioned on an inclined surface or anywhere that makes its plate bend.
We recommend that the power source is not kept on the ground, but that it is raised at
least 25 cm, and that the power cable is outside the working area of the mower. If not, you
may bury it if desired.
Note: Make sure the charging station studs are firmly in the ground and not bent
Note: Do not place the charging station in a closed or confined space.
Stripping boundary wire about 10mm one end.
Boundary wire insert the wire terminal (RED) it's an OUT side, then the boundary wire
through the slot under the charging base plate.
When you laying boundary wire the working area loop, cut off unnecessary wire, Stripping
boundary wire about 10 mm the other end, insert the other wire terminal (BLACK) it's an IN
side.
12
Red
Black
terminal
terminal