Chicco ACTIV 3 Bedienungsanleitung Seite 10

erly attached by pulling it upwards. Check that the "indica-
tors" both show the colour green.
REMOVING THE CARRY COT FROM THE STROLLER
10. With the handle locked in the vertical position (carrying po-
sition) press the buttons on the sides of the plastic adaptors
(Fig. 9) and lift the carry cot off the stroller (Fig. 9A).
WARNING: The fastening and releasing operations can be
carried out with your child inside the carry cot; however,
these operations may be more difficult to execute due to
the child's weight. Pay attention when carrying out the
aforementioned operations.
CLOSING THE CARRY COT
WARNING: These operations must be carried out without
the child in the carry cot or other children in the vicinity.
11. The dimensions of the carry cot can be reduced when
it is not being used. Lower the handle by pushing on
the buttons at the junctions of the canopy (Fig. 6). Then
carry out the operations for the rods described in the
"FIRST ASSEMBLY OF THE CARRY COT" paragraph in re-
verse order.
REMOVING THE LINING OF THE CARRY COT / MAT-
TRESS
12. To remove the mattress cover, take the mattress out of
the carry cot and remove the cover. To remove the carry
cot's fabric lining use the zipper that runs around the
perimeter (Fig. 2).
To fit the lining on the carry cot, follow these same steps in
the reverse order.
LULLAGLIDE STAND: CONNECTING THE ACTIV3 CAR-
RY COT
13. To connect the carry cot, make sure that the stand is in
a fixed position. (Fig. 13).
Before attaching the carry cot, the Mysa Fast-in adaptors
will need to be connected to the Lullaglide stand.
Connect the adaptors by inserting the plastic part into the
lateral graft on the base (Fig. 13A). Repeat the step on the
opposite side. Once the two adaptors have been correctly
assembled on each side, the stand is ready for attaching the
carry cot (Fig. 13B).
To attach the carry cot, hold the handle in the carrying po-
sition (upright and locked) and place the carry cot on the
adaptors (Fig. 13C components A-B); place the carry cot on
the frame until you hear the click confirming attachment
for both adaptors (Fig. 13D). If present, check that the "indi-
cators" on the plastic connectors both show the colour red.
The carry cot can be attached facing in either direction.
WARNING: Before use, make sure that the carry cot is pro-
perly attached by pulling it upwards.
LULLAGLIDE STAND: DETACHING THE ACTIV3 CARRY
COT
14. With the handle locked in the vertical position (carrying
position) press the release buttons on the sides (Fig. 14)
and lift the carryc ot from the structure (Fig. 14A).
WARNING: The fastening and releasing operations can be
carried out also with your child inside the carryc ot; howe-
ver, the child's weight may make these operations more dif-
ficult. Pay attention when carrying out the aforementioned
operations.
DISCONNECTING THE ADAPTORS
15. To remove the adaptors pull on the internal lever and lift
upwards (Fig. 15).
WARRANTY
The product is guaranteed against any lack of conform-
ity under normal use as specified in the instructions. The
warranty shall not therefore apply in the case of damage
caused by improper use, wear or accidental events. For the
duration of the warranty on conformity defects, please refer
to the specific provisions of national laws applicable in the
country of purchase.
10