Ronix RH-4792 Bedienungsanleitung Seite 35

OVERLOAD INDICATOR LIGHT
The overload indicator light comes on when an overload of a
connected electrical device is detected, the inverter unit overheats, or
the AC output voltage rises. The electronic breaker will then
activate, stopping power to the generation in order to protect the
generator and any connected electric devices. The output pilot light
(green) will flicker and the overload indicator light (red) will turn on, then
the engine will stop running. If so please follow the following steps:
- Turn off any connected electric devices and stop the engine
- Reduce the total wattage of connected electric devices within the
application range.
- Check for blockages in the cooling air inlet and around the control
unit. If any blockages are found, remove.
- After checking, restart the engine.
ON
ECON
SWITCH
OFF
User Manual
33