Ronix RH-4792 Bedienungsanleitung Seite 33

- Pull the starter handle slowly until resistance is felt. This is the
Compression point. Return the handle to its original position and pull
swiftly. Do not fully pull out the rope. After starting, allow the starter
handle to return to its original position while still holding the handle.
Grasp the carrying handle firmly to prevent the generator from fall-
ing over when pulling the recoil starter.
- Warm up the engine.
- Turn the choke lever back to the RUN position.
 
RUN CHOKE
- Warm up the engine without a load for a few minutes.
USING ELECTRIC POWER
AC APPLICATION
- Check the AC pilot lamp for proper voltage.
- Turn off the switch(es) of the electrical appliance(s) before connecting
to the generator.
- Insert the pulg(s) of the electrical appliance(s) into the receptacle.
31
User Manual