Commend XDX SHMM Kurzanleitung

XDX SHMM
Mounting kit to install a surface mount kit XDX SH or XDX SHE to a door mullion.
Mounting
Mounting with XDX SH
Drill two mounting holes in the door mullion (see "Dimensions"). A borehole with a diameter of
3.5 mm is required for the supplied self-tapping screws. Prepare a hole for the cable gland.
Mount the mounting plate on the door mullion using two self-tapping screws so that the mounting
bolts face away from the door mullion. Guide the cable through the opening. The mounting kit is
symmetrical and can be installed with the openings on the left or right. It is recommended to seal
the mounting plate to the door mullion.
Depending on the mounting side, break out the provided cable openings.
(Mounting with XDX SHE only) Depending on the mounting side, break out the mounting holes.
Mount the surface mount box XDX SH or XDX SHE on the mounting plate using the four nuts.
Recommended mounting height and position
• Mount the upper edge of the Intercom station approx. 1,650 mm (65 in) from the finished floor.
Adapt the mounting height to the individual needs.
• For a barrier-free accessibility, it is recommended to mount the Intercom station with enough space
to walls or corners.
• When mounting the Intercom station, pay attention to the correct camera angle in terms of
accessibility, so that wheelchair users and children can be detected by the camera (see data sheet
of the Intercom station).
Mounting instructions
• This kit shall be installed by trained and qualified personnel only.
• Only use recommended tools when installing this kit.
• Do not install this kit on unstable walls or on surfaces which cannot support the weight of the
device.
• Make sure this kit is not subject to torsional forces (e.g. on uneven walls).
• Install the Intercom station with a distance of min. 150 mm (6 in) downwards to enable access to the
locking screws (Tx08) of the Intercom station.
• The door mullion width must be min. 25 mm (1 in) for the installation of the mounting kit.
Mounting with XDX SHE
Dimensions
Measuring units in mm (in), not to scale!
12 (0.47)
7 (0.28) 16 (0.63)
Dimensions for boreholes
1)
(ø 5 mm/0.2 in)
Extent of supply
• Mounting plate
• 4 self-tapping screws (ø 3.5 mm/0.14 in; Phillips recessed head)
• 6 nuts (SW 5.5 mm/0.22 in)
• Short reference
Required tools
• Phillips screwdriver (PHD3)
• Nut driver (SW 5.5 mm/0.22 in)
Manufacturer's reference
For technical specifications, see the respective data sheet.
For the latest software and documentation, visit: www.commend.com
Keep this description in safe custody.
Type: D-BZ-XDX-SHMM, Version: 1.1/0523 Commend International GmbH, Saalachstraße 51, A-5020 Salzburg – www.commend.com
2
(0.08)
84 (3.31)