Diadora RQ 400 Bedienungsanleitung Seite 27

B
Step 4:
NOTE: Before assembly, slide the seat (no. 36) in front of the slide rail (no. 3) to prevent it from sliding down during
assembly.
# 58 M8*15 4pcs
# 60 M8*15 4pcs
# 71 OD16*ID8*1.5
#74 S5 1pc
Step 5
: Connect the 2 sensor cables (no. 99) to the cables of the monitor (no. 46). Ensure that the sensor cables are routed
through the opening in the carrier plate.
Fasten the monitor (no. 46) to the support plate (no. 6) with 2 screws (no. 64). Tighten with a wrench (no. 75). Note: the 2
screws (no. 64) are pre-installed on the back of the monitor (no. 46). Make sure that it is not too tight in order to adjust the
angle of the monitor (no. 46).
46
# 64 M5*12 2pcs
1pc
#75 S13-15
4pcs
36
3
71
60 71
58
1
46
6
99
99
Attach the slide rail (no. 3) to the main frame (no. 1)
using 4 washers (no. 71), 4 screws (no. 60) and 4 flat
screws (no. 58). First screw all 8 screws partially into the
holes and then tighten them using the Allen key (no. 74).
60
58
64
26
OPERATING INSTRUCTIONS