Removing The Device - T.i.p. R8 Akku Original-Gebrauchsanweisung

Translation of original operating instructions
Fig. 2
5.4. Possible change of direction of travel
There is an adjustable control nozzle on the front and rear of the cleaner for the drive in the water. By adjusting
the two nozzles, the direction of travel can be changed. If the preset travel angle is not satisfactory, stop the
cleaner, carefully remove it from the water and then bring the control nozzles into the correct position (Fig. 3).
Now carefully put the cleaner back into the pool and start the cleaning process again.
Fig. 3
The direction of travel changes automatically within a fixed time interval Both control nozzles alternate
continuously.
Adjustment of the control nozzles:
- The forward/reverse nozzles are set differently (straight & right or left):
o
The cleaner always travels straight ahead in one direction, and after changing direction to the
right or left (depending on the setting)
▪
- Both sides are set the same (each turned in the same direction):
o
The cleaner moves in an arc to the left - even after changing direction
▪
- Both sides are straight:
o
The cleaner always moves straight forward and back again.
▪
The aforementioned settings are the recommended default settings. Other settings may be more suitable for your
pool.
5.5.

Removing the device

When the battery is drained, the cleaner stops automatically. Attach the hook to your rod (not included). Using the
plastic ring, pull the robot carefully towards you and to the surface. Make sure that the underside is facing the pool
wall. Press the ON/OFF button to switch off the appliance.
Slowly take the pool robot out of the pool by the handle and hold the pool robot over the pool to allow the water
inside to run out. (fig. 4)
Suitable for most pools
Suitable for circular pools
Is not suitable, as no area change can take place
4